The original plan was to add a 5 volt regulator in the Dension cradle cable. I was planning to add it about 6 inches from the connector and heat shrink it when I was done like some sort of cable goiter. As I was checking out the back cavity of the cradle I realized that the regulator would damn near fit inside it. However, with the metal attachment bracket it wouldn’t quite fit. I ground down the metal bracket and sanded down the regulator a bit and everything fit perfectly. I added filter caps before and after the regulator to suppress noise and called it as day. The cradle is working well and is ready to install. As usual, pictures are below.